This is an all steel 3/16" plate framed Prusa styled Printer. The electronics cabinet is integral to the frame yet detachable. The Raspberry Pi is installed in the upper ventilated cabinet. The Web camera is a $12.00 Logitech C170. It functions perfectly! I'm using Makerbot 1.75 PLA at 215 C. 55 C heated bed first layer, heat bed off after. The print cooling fan is running at 50% or so, so that I don't forget to turn it on later when it gets to the really small stubs at the end of the print, otherwise it isn't needed. I threaded the holes on the rear of the larger X-Axis linear bearing to 4mm x 0.7mm pitch to bolt on the cooling duct. About the glue... I've read that Elmer's Disappearing Purple glue works well, too... so I'll give it a try and let you know!
Wirelessly control your 3D Printer - OctoPrint Tutorial - 3D Printing Beginners Guide (Software)
None of the audio/visual content is hosted on this site. All media is embedded from other sites such as GoogleVideo, YouTube etc. Therefore, this site has no control over the copyright issues of the streaming media.
All issues concerning copyright violations should be aimed at the sites hosting the material. This site does not host any of the streaming media and the owner has not uploaded any of the material to the video hosting servers. Anyone can find the same content on Google Video or YouTube by themselves.
The owner of this site cannot know which documentaries are in public domain, which has been uploaded to e.g. YouTube by the owner and which has been uploaded without permission. The copyright owner must contact the source if he wants his material off the Internet completely.